Danby DDW2405BL El manual del propietario

Installation InstructionsBuilt-In DishwasherModel(s):DDW2405W DDW2405BL DW2406BLSBEFORE YOU BEGIN:Readthese instructions completelyand carefully.

STEP 12 CONNECT DRAIN LINEFOLLOW ALL LOCAL CODESAND ORDINANCESThe drain hose molded end will fit 5/8”, 3/4” or 1”diameter connections on the air gap

STEP 13 CONNECT POWER SUPPLY• Remove junction box Cover “ A “.• Locate the three dishwasher wires, (white, black and green) with stripped ends. I

STEP 16 REPLACE KICKPLATE• Tear down the adhesive tape on the kickplate.• Place both kick plate pieces against the kickplate bracket, let the two ho

Installation PreparationPARTS SUPPLIED:• Two #8 Phillips flat head wood screws 5/8”long to secure dishwasher to underside ofcountertop. (Screws can be

INSTALLATION PREPARATIONPREPARE DISHWASHER ENCLOSURE• The dishwasher must be installed so that thedrain hose is no more than 10 feet in length forprop

PREPARE ELECTRICAL WIRINGWARNING:FOR PERSONAL SAFETY:Remove house fuse or open circuitbreaker before beginning installation.Do not use an extension co

PREPARE HOT WATER LINE:•The hot water line may enter from either side, rear orfloor within the shaded area shown in Fig. 6• The line may pass through

STEP 2 ADJUST LEVELING LEGSMeasure installation height and dishwasherheight. Extend leveling legs out from the dish-washer base, 1/4” less than instal

STEP 7 SLIDE DISHWASHERPARTIALLY INTO CABINETTO AVOID DAMAGING THE FRONT PANEL, DO NOT PUSH CABINET IN WITH KNEES.• Slide dishwasher into the opening

STEP 8 POSITION DISHWASHER UNDER COUNTERTOP• Check to be sure that wires are secure under thedishwasher and not pinched or in contact withdoor sprin

STEP 10 SECURE DISHWASHERTO CABINETThe dishwasher must be secured tothe countertop. • Position the dishwasher so that the tub flangealigns with t