Danby DKC646BLS El manual del propietario descargar pdf (Pagina 13)

PREPARACIÓN DE SU BARRIL REFRIGERADOR

INSTRUCCIONES

DE ARMADO

1. Instalación de la barandilla: Instale los dos rieles cromados

usando un destornillador Phillips #2 y los cuatro tornillos

autorroscantes incluidos, tal como se indica en la Fig. 1.

2. Instalación del regulador de CO2: Fije el regulador de CO

cilindro de CO

atornillando la tuerca del regulador en la

válvula del cilindro y ajustándolo con una llave ajustable.

Ver Fig. 2

3. Instalación del cilindro de CO

: Coloque su cilindro cargado

de CO

sobre el soporte.

TA IMPORTANTE: TENGA SIEMPRE MUCHO CUIDADO AL

MANIPULAR CILINDROS CARGADOS DE CO2.

4. Instalación del soporte de cilindro de CO2: . Alinee los orificios

del soporte del cilindro con los tachones y presione firmemente.

Ver Fig. 3

SETTING UP YOUR KEG COOLER

1. Unplug the keg cooler and

place the unit on its back..

2. Remove the kickplate by

removing the three retaining

screws (Fig. E1)

3. Remove the four screws

from the lower support

(

Fig.E2) and remove the

lower support.

4. Pull the door downward until

it releases from the upper

hinge pin.

5. Remove the plastic screw

caps from the top left hand

side and install it on the top

right hand side of the door

frame.

6 Unscrew the upper door

hinge pin (Fig E3) from the

right side of the worktop

and install it on the left side

of the worktop.

7. Position the main door on

the cabinet and push up

until the upper hinge pin is

inserted into the top of the

door.

8. Remove the lower support

pin from the lower support

and reposition it as shown

in Fig. E4).

9. Reinstall the

lower support pin on

the lower right side of

the door.

10. Make sure to align the door

with 1) the cabinet, and 2)

the lower support pin before

reinstalling the bottom-plate

and its four (4) screws.

11. Reinstall the kick-plate.

IMPORTANT!

Allow the unit to stand upright

for 1 hour before putting the

unit into operation.

WARNING!

Excessive Weight Hazard

Use two or more people to

move and install the keg

cooler.

Changing Direction

of the Door “Swing”

IMPORTANT NOTICE: Before proceeding with the configuration

options on this page, remove keg and the CO

2 cylinder (if installed)

from the Keg Cooler. Once complete, allow the unit to stand

upright for 1 hour before putting the unit into operation.

TOOLS REQUIRED: Phillips #2 screwdriver

Fig. E3

Fig. E2

Fig. E1

Fig. E4

Fig. 2

Castor Installation

1. Lay the unit on it’s back.

2. Using the 16 machine screws

provided, install each of the 4

castors in the threaded holes

located in each corner of the

unit as shown in Fig.A.

Fig. A

The locking swivel castors

should be installed in the

front of the unit for easy

access.

Fig. 3

Fig. 1

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 21 22

Comentarios a estos manuales

Sin comentarios

Danby DKC646BLS El manual del propietario Pagina 13

Comentarios a estos manuales